Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
KraftMaid Roofing: The Long Beach Owner’s Guide
We stock and install KraftMaid-compatible roofing components in Long Beach, and a typical repair runs $400 to $1,800 depending on the part, the roof pitch, and how much flashing needs to be redone. Most KraftMaid roofing issues we see are discovered the hard way: a water stain on the ceiling after a rain, a shingle in the front yard, or a neighbor mentioning they can see something flapping up by the ridge vent. The good news is that roofing failures are usually obvious once you know what to look for, and most KraftMaid part replacements can be handled same week, not same season.
KraftMaid is known for cabinetry far more than roofing, which means their roofing line is smaller and often overlooked when people search for replacement parts. If you’re holding a faded KraftMaid shingle wrapper or the spec sheet from your original build, you’re already ahead of most homeowners we talk to. We’re an independent Long Beach contractor with KraftMaid material access, not a KraftMaid corporate service arm. That means we can source the part and install it without routing through a national call center.
Which KraftMaid Models This Applies To
KraftMaid’s roofing product line falls into three buckets we work with regularly in Long Beach: their asphalt shingle series, their ridge vent and flashing kits, and a smaller lineup of roof deck underlayment products. The asphalt shingles are the ones we replace most. They’re sold in standard architectural profiles that mirror the dimensions you’d find from GAF or Owens Corning, which is helpful, because it means the replacement doesn’t have to be a KraftMaid-branded shingle to match the roof line.
Here’s the compatibility gotcha most owners miss: KraftMaid’s older shingle lines from the late 2000s and early 2010s used a slightly narrower exposure than current architectural shingles. The old exposure was 5-5/8 inches. Today’s standard is 5-5/8 to 6 inches depending on the manufacturer. It’s close enough that a full roof looks fine, but if you’re only replacing a section, you can end up with a visible seam where the old and new rows don’t quite line up. We measure exposure on-site before any repair quote. For ridge vents and flashing, KraftMaid parts are more universal, and we typically pair them with GAF ridge vent components when the original KraftMaid part is discontinued, which happens more often than we’d like with their older roofing accessories.
If you’re trying to identify what you have, look for the KraftMaid SKU printed on the shingle wrapper or the metal edge of the ridge vent. No wrapper? A roofline photo from the ground and a rough idea of the build year usually gives us enough to match the profile.
Styles & brands we work with
Signs Your KraftMaid Roofing Is Failing
- Granule loss in the gutter or at the downspout base. Asphalt shingles shed granules as they age, but a heavy buildup of dark grit at the gutter corner after a dry week means the shingle surface has broken down and the underlying asphalt is exposing. In Long Beach’s sun exposure, KraftMaid shingles on a south-facing slope can start shedding noticeably around year 15 to 18, versus 20 to 25 for shaded slopes.
- Curling at the shingle corners or edges. This is the classic Long Beach failure pattern: the ocean-adjacent humidity keeps the shingle slightly damp, and the afternoon sun bakes it dry. That repeated cycle curls the corners first. Curled edges catch wind, and wind pulls more shingles loose. It compounds fast once it starts.
- Water staining on the ceiling after rain. By the time the ceiling shows it, the water has already traveled through the shingle, the underlayment, and often the decking. The shingle leak itself may be a small puncture or a failed nail seal, but the damage path is long. Don’t wait on this one; the repair grows every storm.
- A shingle or shingle piece on the ground after a Santa Ana wind event. Long Beach gets gusts that will find any weak nail line or failed adhesive strip. If one shingle tore off, the ones adjacent to it took the same wind load and likely have broken seal strips too. A single missing shingle is rarely a single shingle problem.
- Visible sagging between the rafters when you look up from inside the attic. This one signals decking rot from long-term moisture intrusion. The shingles above may look fine from the ground. The deck underneath is the problem. We see this most often in older Long Beach homes with original 1970s and 1980s roof decks that went through decades of fog cycles before the shingles were ever replaced.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Long Beach, a KraftMaid shingle repair typically runs $400 to $1,800. A single shingle tab or small section replacement with matching material lands at the lower end. The upper end covers ridge vent replacement, multiple shingle bundles with new underlayment, or flashing work where a roof plane meets a wall or chimney. A full KraftMaid roof replacement on a standard Long Beach home runs $8,000 to $20,000, which aligns with what you’d pay for quality architectural shingle work in this market.
What drives the range: roof access and pitch (a 7/12 or steeper roof costs more than a low-slope ranch), how much decking needs to be replaced once we open it up, whether the existing underlayment is salvageable, and whether the original KraftMaid shingles can be matched with a current product or need a compatible substitution. Our written quote breaks out parts and labor separately, so you know exactly what the shingle cost is and exactly what the labor cost is. Every repair includes our 365-Day Done Right Promise: if it’s not done right, we make it right, in writing.
DIY or Call Us?
Here’s the honest split. You can safely clear debris from the gutter, photograph the roof from the ground, and check inside the attic for daylight or water trails. That’s useful. What you shouldn’t do is climb onto a Long Beach roof with a bundle of shingles from the hardware store and hope for the best. A roof is a working surface that punishes mistakes. Falls from residential roofs are a leading cause of serious injury in home repair. Beyond the fall risk, a mis-nailed shingle row leaks, and the water damage underneath costs more than the original repair ever would. Roofing is not the place to learn by doing. If you’ve got a failing KraftMaid roof section, the fastest, safest fix is a call to us at (562) 512-6480 for a free estimate. We’ll measure, quote a written price, and handle the ladder work.
FAQs
In Long Beach’s mixed sun and coastal humidity, KraftMaid asphalt shingles typically last 18 to 22 years on average. South-facing slopes with direct all-day sun trend toward the shorter end, while shaded north-facing slopes can outlast that range. Granule loss and curling are the first visible signs to watch for.
Yes, if the damage is localized and the surrounding shingles still have seal integrity. We repair the damaged section, match the shingle profile as closely as current product allows, and re-check the surrounding rows for loose adhesive strips. Call (562) 512-6480 for an exact assessment, estimates are free.
Most repair jobs are done in one visit, usually four to eight hours depending on the section size and whether underlayment or decking needs replacement. We schedule a specific day with you, and you’ll know before we start if it’s a one-day job or will carry to a second day.
We stock common KraftMaid-compatible shingle profiles, standard ridge vent components, and matching flashing in our Long Beach trucks. If your roof needs a specific discontinued profile, we source it before the scheduled work day so you’re not waiting on a second trip. We also carry parts for other brands our clients ask about, including Cambria, Silestone, and Kohler, though roofing work is the KraftMaid category we handle most.
Written by Luca Romano, Owner, Sawyer Remodel Long Beach at Sawyer Remodel Long Beach, serving Long Beach and nearby areas.
